Aluminium Intercooler - Volvo 240 / 700 / 900 Turbo

This performance intercooler is developed to replace the original / OEM intercooler and gives true performance without the need of rebuilding the whole car!

Significant advantages of this performance intercooler (OEM intercooler):

- Core volume: 11906cm3 (5377cm3), do88 is 221% larger!
- Air flow at 0,15bar/2,18psi pressure drop: 405CFM (286CFM), do88 42% higher!
- Fits all cars in list below with very small modifications!
  The OEM intercooler rubber supports in both the top and bottom needs to be trimmed slightly
  because of the increased thickness.

This performance intercooler are an all aluminium construction with cad designed, flow optimized cast end tanks and optimized core design (60mm thick) to achieve best possible cooling efficiency combined with lowest possible pressure drop!

Always remember that the OEM intercooler was designed for the power level the car was built for and a power increase or even very hard use of the car in a standard version may cause that the OEM intercooler don’t have the performance you need. So only after engine software tune this performance intercooler will give a performance increase over the OEM intercooler!
The OEM intercooler have plastic tanks that don’t keep up with higher boost levels very well so the do88 performance intercooler will also add reliability!

A common misunderstanding is that an intercooler installed in this position cannot provide good performance and a front mounted intercooler / FMIC would be much better. But actually the do88 performance intercooler are far better than most FMIC installations where only a core with small front surface are possible to install and often also installed partially behind the bumper beam which will reduce cooling capacity even further and often cooling below the OEM intercooler are achieved.